Flyer pushing aid connecting cable Panasonic 47 Volt CHM Motor

This original connection cable from Panasonic is required if you want to mount the push aid on an electric bike with Panasonic 46.8 volt display.

With three screws, the connection cable is attached to the back of the 48 volt Pansonic display. If the push aid connection cable is defective, the push aid can be quickly repaired.

Connect the push-assist throttle button to the shorter cable. The cable with the round plug socket is used to connect the brake contact switch that comes off the brake lever.

Flyer or KTM 47 Volt push-assist retrofit:

If you would like to install a push assist on your electric bike with Panasonic CHM hub motor, please refer to the following links:

• Flyer throttle knob for push assist - Panasonic 46.8 volt rear wheel motor

The Panasonic connection cable for the push assist fits the following electric bikes:

• Flyer Vollblut
• KTM eRace P
• KTM eCross P
• KTM eStyle P
• other models with Panasonic CHM rear hub motor

The technical characteristics of the Panasonic connection cable for the pushing aid on the electric bike with rear wheel drive on 48Volt basis: